Back cover adhesive for iPhone 17

Description

This adhesive is used to secure the rear cover of your iPhone 17 once it is refitted. It is a double-sided seal that holds the back panel onto the chassis and limits the play that can develop over time. When it is worn, peeled off or removed during a repair, the cover can lift or move slightly, which you notice by touch and by small rubbing noises.

This is a compatible part, made by a third party. It is offered as an affordable alternative to restore a device without looking for the current part. The result depends on how clean the surfaces are and how precisely it is stuck down, but fitting it remains straightforward with a little care.

Before fitting the adhesive, switch off the device, remove the battery if your model allows it, and carefully clean off the old residue with a lint-free cloth and isopropyl alcohol. Work at room temperature, without excessive heat, and avoid touching the sticky side with your fingers. After fitting, let the bond rest for a few hours before putting the device under load, then check that the cover does not move and that any buttons remain easily accessible.

Tips

• Clean the surfaces with isopropyl alcohol before fitting
• Avoid excessive heat during disassembly
• Disconnect the battery before any work
• Never puncture or bend the lithium battery
• Let the bond rest for a few hours before use

Fitting

Fitting guide: work with the device switched off, disconnect the battery before touching any flex cable, keep the screws in order and test the part before closing up. A question before ordering? Write to us.

Specifications

Compatible with

iPhone 17

Part type

Seal / adhesive

Quality

Compatible

Warranty

2-year legal guarantee of conformity

Benefits

• Third-party manufacture: the lowest price to repair
• Compatibility with the stated model checked on the product page
• 2-year legal guarantee of conformity